2015:Apply Control's Mean and SD to Reagent Lot

[Robin Valder]

CLIENT: Sherri Sandin
ORGANIZATION: REGIN
EMAIL: sherri.sandin@rqhealth.ca
FORUM: TotalQC - Lorrain Phelan
MODERATOR: lorrain@softcomputer.com
TOPIC TITLE: Reagent setup, attached control
------------------------------------------------
REASONS TO ADD THE TOPIC: Currently, if you attach a control to a reagent setup, the means and sd's need to be updated in both the reagent setup and the lot record. This is a duplication of work. All means and sd's or ranges should read from the active lot record.

If the user opens a lot record of a Biorad control and enters the Mean and SD for Glucose, then opens a new lot record of the Glucose reagent, the current active Biorad control mean and SD for glucose does not update into the reagent record. Therefore, the Mean and SD for glucose would need to be entered into the lot record for the control and the reagent even though the reagent is linked to a specific control and test.

[Robin Valder]

SCC Evaluation of Enhancement:
Accept/Reject enhancement: Accept
Degree of difficulty: Medium
Estimated programming hours: 35

Provide the ability to assign a test's current Mean and SD of a Control lot record to the corresponding parameter (Parameter control-Test-Workstation) of a Reagent lot record.

MAYO submitted similar request in MAR5-04413/ BUE-04649 and after Business Unit Evaluation deemed an enhancement. No SCR has been submitted.

[Robin Valder]

This item was selected during the 2015 cycle for inclusion in the software, no final vote was necessary since the number of hours for the group did not exceed those assigned.
IFR-24608; REGIN-06890

[Robin Valder]

Completed; included in 1.0.5.0